211 water-based industrial coating has been time-tested and field-proven on a variety of substrates.
Tri-Chem's 211 is an aliphatic polyester polyurethane coating and sealer that was developed without the use of solvents. It has low VOCs, has high-performing moisture barrier properties, and is impact, abrasion, and chemical resistant. 211 is very easy to maintain, reducing product labor and costs.
211 can be used on just about any substrate including, but not limited to: VCT, concrete, epoxy, tile and grout, wood, terrazzo, metal, dry wall, foam, rubber, fiberglass, and previously painted surfaces. This coating outperforms all solvent-based coatings, and can be used on both vertical and horizontal surfaces.
CERAMIC TILE & GROUT
FOAM & STUCCO
PREVIOUSLY PAINTED SURFACES
211 is available in three different finishes.
Areas of Use
The versatility of 211 allows for the coating to be used in all types of industries.
Exceptional Bonding Capabilities – No primers needed; direct to most surfaces
Types of Surfaces – Concrete, stained concrete, carbon steel, aluminum, galvanized metal, stainless steel, fiberglass, wood, clay/masonry surfaces, stone, hardwood, terrazzo, VCT, vinyl sheeting, ceramic and other tile and grout surfaces with Adhesion Bond addition
Interior/Exterior Use – Allows to be used while building is in operation
Very Repairable – Small sections can be repaired without redoing the entire section
Significant Cost Savings – Less coats, no primer needed, labor reduction, longer lasting
Vertical and Horizontal Surfaces – Brush, roll, or spray application
Low to Zero VOCs – VOCs are less than 15 grams/liter
Virtually Odorless – Does not require special breathing apparatus
Produced in Total Water – Does not use solvents
No Proposition 65 Chemicals – These cause cancer and birth defects
Meets US Building Councils’ LEED Criteria – Under EQ 4.2 for low-emitting coatings
Super Compliant Coating – On California’s South Coast Air Quality Management District “Super Compliant” list
ENERGY STAR Qualifies & Cool Roof Rated – Tested for 3 years at 3 different weather farms
Permeability – Water barrier not vapor barrier
Ultraviolet Insensitivity – UV protection in both color and clear
Impact Resistance – Can be hit with a ballpein hammer without cracking, chipping, or adhesion loss
Abrasion Resistance – Less than 30mg loss on 1,000 cycles
Increased Co-Efficient of Friction – Certified by the NFSI as high traction with a wet co-efficient of friction rating > 0.60
Provides Anti-Graffiti Properties – Paint and markers can be removed without damaging coating
Inherent Dry Erase Characteristics – Turn surfaces into dry erase boards